| Display: |
7-segment LED-display
8-digit display of real value
7.6 mm high
Decimal point can be programmed
Suppression of leading zero
Minus sign for negative values |
| Operation, keypad: |
Front membrane w. short-stroke keys |
| Front dimensions: |
DIN housing, 72 x 72 mm |
| Mounting: |
Front installation |
| Fastening: |
Clamping frame |
| Weight: |
Version AC: ca. 450 g
Version DC: ca. 320 g |
| Type of connection: |
Plug-in screw terminals
Grid 5.08 mm |
| Core cross-section: |
Max. 1.5 mm2 |
| Housing material: |
Polycarbonate black, UL 94V-0 |
| Membrane material: |
Polyester |
| Supply voltage: |
Choice of two voltages via switch on device. When supplied, always higher voltage adjusted.
115 ±10 % / 230 VAC +6 %/-10 % (50 / 60 Hz)
24 / 48 VAC ±10 % (50 / 60 Hz)
24 VDC ±10 %, 5 % residual ripple |
| Power consumption: |
7 VA, 6 W |
| Sensor supply: |
12...26 VDC / max. 100 mA |
| Signal inputs: |
Optocoupler inputs
Count inputs A / B
- control current 9...16 mA
- breaking current < 0.5 mA
- input resistance 1.65 kOhm
Control inputs
- control current 5...8 mA
- breaking current < 0.5 mA
- input resistance 3.3 kOhm
PNP, NPN logic can be coded via wire jumper to terminal strip |
| Input counting rate: |
Can be programmed to 15 Hz, 25 Hz, 10 kHz |
| Control inputs: |
3 control inputs for reset, stop, hold, etc. |
| Signal outputs: |
Can be programmed as momentary or permanent signals
Impulse time can be programmed 0.01...99.99 s |
| Relay signal outputs: |
2 floating center-zero relays for main counter
1 floating relay for batch counter, to be programmed as normally open or closed
Internal spark suppression
Max. switch. voltage 250 VAC
Max. switch. power 1 A
Max. switch. capacity 150 VA / 30 W |
| Electronic signal outputs: |
NPN switching transistor
- Max. switching voltage +35 V
- Max. switching power 50 mA
PNP switching transistor
- Max. switching voltage 12...24 VDC with AC operation, depending on load
- Max. switching power 50 mA, for DC operation
- Max. switching power 10 mA, for AC operation |
| Data storing: |
> 10 years via EEPROM |
| Counting mode of signal inputs A / B: |
UP / DOWN, A - B, A + B, A 90° B x1, A 90° B x2, A 90° B x4 |
| Ambient temperature: |
0...+50 °C |
| Storage temperature: |
-20...+70 °C |
| Relative humidity: |
Max. relative humidity 80 %, at 25 °C, non-condensing |
| Protection: |
Front IP 65 to DIN 40050 |
| General rating: |
EN 61010 Part 1
- Protection class II
- Overvoltage protection categ. II
- Contamination factor 2 |
| Interference immunity: |
EN 50082-2 |
| Emitted interference: |
EN 50081-1 |
Features
Specifications
Main counter with two presets
and zero contact
